Endress+Hauser Proline 300 Bedienungsanleitung Seite 15

7.6.2 Transmitter, isolated from ground option
NOTICE
Damage to the measuring device!
The measuring device can be destroyed if the grounding switch is in the incorrect position.
‣
Check that the grounding switch is in the correct position and correct if necessary!
1
‣
Set the grounding switch of the
ISEM to the "right" position
(open).
7.7 General information on reassembling the transmitter
Insert the new S-DAT into the ISEM.  Pay attention to pin diagram!
1 →
‣
Promag
Endress+Hauser
2 →
‣
Promass, t-mass
3 →
‣
Prosonic Flow
EA01278D
15