7.9
Installing the transmitter housing for hazardous areas
1
1.
2.
4 mm
3.
‣
Installation of the transmitter version for hazardous areas: Fit the
transmitter in place, turn it and tighten the screws.
For detailed information on the electrical connection, see the "Electrical connection"
section of the Operating Instructions for the device.
For detailed information on commissioning, see the "Commissioning" section of the
Operating Instructions for the device.
7.10
Assembling the connection compartment cover and electronics
compartment cover for the hygiene housing
1
2.
1.
‣
Fit the cover on the cover, tighten it by hand and then by 45° using a
screwdriver.
Endress+Hauser
4.
2,5 Nm
(1.8 lbf ft)
T20
3.
45°
EA01278D
17