Yamaha FX500B Bedienungsanleitung Seite 21

• MIDI Setup
This function makes it possible to select any of the four
available program change table BANKs, and to change the
MIDI receive channel for each BANK.
® ©
© Use the UTILITY key to select the MIDI SETUP display.
(2) The underline cursor should be under the BANK
parameter. Use the Aand Ykeys to select the bank
you wish to program (A, B, C or D).
(3) Move the cursor to the "ch=" parameter by pressing the
PARAM (►) key, then use the Aand Ykeys to set the
receive MIDI channel (1 —16), the OMNI mode (all
channels can be received), or turn MIDI reception OFF
for the selected bank. The underline cursor can be
moved back to the BANK parameter if necessary by
pressing the MEMORY
(A)
key.
• Program Change Table Edit
When this function is called the LCD will appear as shown
below, and it becomes possible to assign new memory
location numbers to each MIDI program change number.
© Use the UTILITY key to select the MIDI PGM CHANGE
display. The underline cursor should be under the PGM
parameter.
I
M I D I P G 1 C HRN6E
P B M 1
= MEM 1
(2) Use the Aand Ykeys to select the program change
number to which a new FX500B memory location
number is to be assigned. The range of available
program change numbers is from 1 to 128.
(D Move the underline cursor to the MEM parameter by
pressing the PARAM (►) key. Use the Aand Ykeys to
select the memory location number containing the
effect which is to be assigned to the currently selected
program change number.
Ifis selected, no new memory location will be
selected when that program number is received.
(4) Move the underline cursor back to the PGM parameter
by pressing the MEMORY (^) key and repeat the
above steps to assign as many program change
numbers as necessary.
NOTE:
The program number/memory number
assignments made are stored in the BANK
selected in the previous MIDI Setup function. To
program the program change/memory number
assignments for a different BANK, return to the
MIDI CONTROL display, select the desired BANK,
then program the required assignments.
NOTE:
Although the BANK A, B, and C program change
tables are retained in memory even when the
power is off, the BANK D program change table is
automatically initialized whenever the FX500
power switch is turned on (PGM number - MEM
number). Make sure you program PGM/MEM
assignments you want to keep in BANK A, B, or
C.
■
MIDI Parameter Control: Control
Change 1 Table Edit and Control
Change 2 Table Edit
The FX500B allows two MIDI "controllers" to be assigned
for remote real-time control of effect parameters. "MIDI
controller" actually refers to a MIDI CONTROL CHANGE
number between 0 and 127. Some of these numbers are
assigned to specific controllers — modulation wheel, data
entry, etc— and a MIDI device such as a keyboard or
MFC1 MIDI Foot Controller that has the any of these
controllers will transmit the corresponding MIDI control
change data when the controllers are operated. You could,
for example, assign an FC7 connected to an MFC1 to
control the FX500B reverb time.