Zodiac RE 42 Installations- Und Gebrauchsanweisung Seite 9

Attachment to the base
2.2
I
2.3 I Electricity supply connection
In order to avoid any risk of electrocution, fire or serious injury, please follow the instructions
below:
• Use of an electrical extension is prohibited when connecting the control box.
• Make sure that the socket can be easily accessed at all times and is protected from rain or
splashes.
• The control box is impervious to spray but must not be immersed in water or any other liquid.
It must not be installed in a floodable area; keep it at least 3.5 metres away from the edge of
the pool and avoid exposing it to direct sunlight.
• Place the control box near the socket.
• Connect the floating cable into the control box (see figure
• Push the connector in until you hear 2 clicks (see figure
If it is not, repeat the operation.
• Connect the power cord (see figure
maximum residual current device (if in doubt contact a qualified technician).
• To disconnect the floating cable from the control box, pinch the 2 clips at the end of the connector and pull at the
same time (see figure
8
.
) Only connect the control box to a power outlet protected by a 30 mA
.
)
).
). Make sure the connector is sufficiently pushed into place.
CLICK
CLICK