Zodiac RE 42 Installations- Und Gebrauchsanweisung Seite 23

5.3 I Troubleshooting the connection to the iAquaLink™ app
Control box status
LED is
• The
flashing.
• All LEDs are off.
LED is off.
• The
LED is
• The
lit but the Wi-Fi
connection is non-
existent (or spotty).
The "Connection
Error" message
is displayed on
the screen in the
iAquaLink™ app.
22
Possible causes
• The version of the app
used is obsolete.
• The control box is
connected to the router
but not to the cloud
server (LAN connected,
WEB not connected).
• Incompatible 5 GHz
router.
• Very high luminosity.
• Control box
disconnected.
• Power cut.
• Internet connection lost. • Check the internet connection - the network may be down.
• Internet connection lost.
• Weak Wi-Fi signal*.
• The control box is too
far from the home Wi-Fi
router.
Solutions
• Update the app version.
Contact your Internet service provider.
• Disconnect the home Wi-Fi router for 10 seconds. Re-
connect it and see whether the LEDs come back on.
• Check the internet connection - the network may be down.
• Replace the router.
• Cover the appliance to protect it from the sun's rays and
check that the light indicators turn on.
• Connect the control box (see "2.3 I
connection").
• Check that there is power to the circuit breaker.
• Check that there is power to the socket by connecting
another appliance to it.
• Check the internet connection - the network may be down.
• Ensure that you have a sufficiently strong Wi-Fi signal. There
are several ways to check the strength of the Wi-Fi signal:
- Unplug the home Wi-Fi router, then plug it back in.
- Using a laptop, go into Configuration Panel to see the
status of your network connections. Check the strength
of the wireless network signal on the laptop by checking
the status of the control box connection.
- Install the iAquaLink™ app, using a smartphone or tablet.
Check the strength of the wireless network signal on the
mobile device by checking the status of the control box
connection. If the Wi-Fi network is weak, install a Wi-Fi
extender.
- Use an app dedicated to analysing the Wi-Fi connection:
several are available in iOS or Android.
• On initial set-up, place the cleaner's control box as close as
possible to the home Wi-Fi router. Do not use an electrical
extension (see "2.3 I Electricity supply connection"), then
repeat the configuration steps (see "3.1 I First-time cleaner
configuration"):
- Once the LED lights up, plug in the control box near
the pool.
- If the LED does not light up, plug in the control box
again as close to the house as possible.
- If the LED still does not light up, install a Wi-Fi
extender.
Electricity supply