Zodiac RE 42 Installations- Und Gebrauchsanweisung Seite 11

2.5 I Starting a cleaning cycle
In order to avoid any risk of injury or material damage, please follow the instructions below:
• Bathing is prohibited when the appliance is in the pool.
• Do not use the appliance during a shock chlorination. Wait until the chlorine level has reached
the recommended value before immersing the cleaner.
• Do not use the appliance if the roller shutter is closed.
• The control box switches to standby after 10 minutes. Press any key to exit standby mode. Standby mode does not
stop the appliance if it is in a cleaning cycle.
2.5.1 Choice of cleaning mode
• The cleaning mode defines the surface to be cleaned and the duration of the cleaning cycle.
• By default, a cleaning mode "Floor + walls + water line" is pre-configured (the symbols are lit).
• The cleaning cycle can be modified before the appliance starts or while it is operating. The new mode will be started
immediately and the remaining time from the previous cycle will be reset.
For dual-filtration models, launch several cycles without the very fine debris filter to pre-clean
•
the pool.
• Press
2.5.2 Launching the cleaning cycle
• Press
The cleaner adapts its movement strategy to the cleaning mode, in order to optimise its level of coverage.
Tip to improve cleaning performance
At the start of the bathing season, launch several cleaning cycles in bottom only mode (after removing the
large debris with a net).
Regular use of the cleaner (without exceeding 3 cycles per week) means that your pool will always be clean
and the filter less clogged.
10
Surface to be cleaned
Floor only
Floor + walls + waterline