Zodiac RE 42 Installations- Und Gebrauchsanweisung Seite 3

WARNINGS ASSOCIATED WITH ELECTRICAL APPLIANCES
• The power supply to the appliance must be protected by a dedicated 30 mA Residual
Current Device (RCD), complying with the standards and regulations in force in the
country in which it is installed.
• Do not use any extension lead when connecting the appliance; connect the appliance
directly to a suitable power supply.
• Before carrying out any operations, check that:
- The required input voltage indicated on the appliance information plate corresponds
to the mains voltage;
- The mains supply is compatible with the appliance's electricity needs and is correctly
grounded.
• In the event of abnormal operation or the release of odours from the appliance,
turn it off immediately, unplug it from its power supply and contact a professional.
• Before servicing or performing maintenance on the appliance, check that it is
powered off and completely disconnected from the power supply and that all other
equipment or accessories connected to the appliance are also disconnected from
the power circuit.
• Do not disconnect and reconnect the appliance to the power supply when in
operation.
• Do not pull on the power cord to disconnect it from the power supply.
• If the power cord is damaged, it must be replaced by the manufacturer, an authorised
representative or a repair facility
• Do not perform maintenance or servicing operations on the appliance with wet
hands or if the appliance is wet.
• Before connecting the appliance to the power supply, check that the connection
unit or socket to which the appliance will be connected is in good condition and
shows no signs of damage or rust.
• In stormy weather, disconnect the appliance from the power supply to prevent it
from suffering lightning damage.
SPECIFIC FEATURES APPLICABLE TO "Pool cleaners"
• The cleaner is designed to operate properly in pool water at a temperature of
between 10°C and 35°C.
• To avoid possible injury or damage to the cleaner, do not operate the cleaner out of
the water.
• In order to prevent possible injury, bathing is prohibited when your cleaner is in the
pool.
• Do not use the cleaner during shock chlorination.
• Do not leave the cleaner unattended for an extended period.
WARNING ON THE USE OF A CLEANER IN A POOL WITH A LINER
• Before installing the cleaner, carefully inspect the pool lining. If the liner comes
away or is damaged in places, or if stones, folds, roots or corrosion appear, do not
install the cleaner before a qualified professional repairs or replaces the liner. The
manufacturer may not be held liable in any way for damage caused to the liner.
• The surface of certain patterned liners can wear away quickly: the patterns and/
or colours can become deteriorated, faded or disappear on contact with certain
objects (cleaning brushes, toys, rubber rings and floats, chlorine dispensers, or
cleaners). The cleaner manufacturer may not be held liable for wear to the liners or
faded patterns, which are not covered by the limited warranty.
WARNING ON THE USE OF A CLEANER IN A STAINLESS STEEL POOL
• Some stainless steel pools may have very fragile surfaces. The surface of these
pools might get damaged by the basic friction of debris against the surface, for
example caused by the wheels, tracks or brushes of cleaners, including electrical
pool cleaner. The wear or scratching of stainless steel pools are not the liability of
the manufacturer of the pool cleaner and are not covered by the limited warranty.
2
only.