Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The Provox Micron HME and other Provox HME Cassettes are
intended to be used with the following attachment devices and
accessories in Provox HME System.
For more information read Instructions for use for each of
the products.
Provox
Adhesive base plates are single use devices that are
®
intended to hold Provox
Cassettes in front of the tracheostoma and to provide an airtight
seal. The self-adhesive tape discs are supplied on a peel-away
paper liner and come in two different shapes, i.e. oval (anatomi-
cal) and round, and three different types of glue: OptiDerm,
FlexiDerm and Regular.
A special version, Provox
adhesive that has a conically shaped base. It is designed to facil-
itate and improve skin attachment for deep stomas and / or if
an automatic tracheostoma valve Provox
used.
OptiDerm (fig 1a) is intended for patients with a sensitive
skin or if the skin is not yet healed properly, e g after surgery
and/or irradiation. It absorbs moisture, is gentle to the skin and
needs less frequent replacement. It can be applied gently on the
1st postoperative day. Average durability 36 hours.
FlexiDerm (fig 1b) is very flexible and has the strongest adhe-
sive properties. It is especially suitable for patients with a deep
and/or irregular stoma or who prefer a very soft and flexible
adhesive. Due to the type of glue used, a suitable skin cleanser
is recommended to clean the skin of any residual glue. Average
durability 48 hours.
8
Attachment devices
Provox
Adhesive
®
Micron HME and other Provox
®
XtraBase, is a Flexi-Derm type
®
FreeHands HME is
®
HME
®
Werbung
