Atos Medical PROVOX HME Bedienungsanleitung Seite 10

Replacement of the Adhesive base plate
The Adhesive base plate can stay in place as long as it is glued
properly to the skin. To facilitate removal of partially attached
Adhesives, the use of adhesive remover, e.g. Remove™ may
be helpful. After Remove™ is used the skin should always be
cleaned with a cleaning towel or soap and water. Read instruc-
tions. Before applying a new Adhesive base plate, the skin should
be carefully cleaned and dried.
CAUTION: When cleaning the skin from residual glue, prevent
particles/fluids from entering the stoma. In case of using OptiDerm
in the postoperative period or sensitive skin, the Adhesive should
only be replaced when completely loose.
Storage
Store in a clean, dry and dark area at room temperature
(15°C–25°C/60F–80F).
Provox LaryButton™
®
Soft silicone laryngectomy stoma buttons (fig 1d).
- with or without using Provox LaryClip or Provox TubeHolder.
® ®
Read separate instructions.
Provox LaryTube™
®
Soft silicone laryngectomy tubes (fig 1e).
- with or without using Provox LaryClip or Provox TubeHolder.
® ®
Read separate instructions.
10