Cleaning And Care - Rondell Rde-1642 Betriebsanweisung

Set the roasting time depending on the weight of the ingredi-
ents and your preference in roasting degree.
Dough rise
This program is intended only for rising the dough prepared on
the bread starter. After the program is finished, you can use the
ready dough for homemade pastry.

CLEANING AND CARE

– Unplug the unit and let it cool down.
– Wipe the body and lid (3) with a wet cloth.
– Wash the bread pan (5), the paddle (6), the measuring cup
(8), the spoon (7) and the hook (9) in warm water with a neu-
tral detergent.
Troubleshooting
Malfunction
Symbols «HHH» appear on the
display
Symbols «LLL» on the display
Symbols «Е», «Е0» or «Е1» on
the display
Smoke from the ventilation
openings
The baked bread fell, the bottom
part of the bread is damp
The bread has stuck to the walls
of the bread pan
The bread maker does not mix
the flour and does not work
Unusual noise
Note: If the paddle (6) can not be removed from the axle,
fill the pan (5) with warm water and wait for about 30 min-
utes.
– You may also wash the pan (5) and the paddle (6) in a dish-
– Dry the pan (5) and the paddle (6) carefully before fixing
– Do not immerse the unit, power cord and power plug into
STORAGE
– Before storage clean the unit and wait until it is completely
– Keep the unit away from children in a dry cool place.
Possible causes
The unit has not cooled down
after the previous baking cycle
Low temperature in the baking
chamber
Temperature sensor failure
Ingredients got onto the
heating element
The bread has stayed in the
bread maker for too long after
baking
The bottom part of the bread
has stuck to the kneading
paddle
Check whether the power cord
is connected to the mains
socket
the delayed start function is
activated.
Bread maker malfunction
Some hard objects or bread
crumbs got into the bread
pan (5)
The kneading paddle (6) is
installed improperly.
25
washer.
them in the bread maker.
water and other liquids.
dry.
Possible solution
Unplug the unit, take the pan out, let the unit cool down at
room temperature
Switch the unit off, open the lid and wait for 10-20 minutes
Switch the unit off and contact the authorized service
center
Switch the unit off by pulling the power plug out from the
mains socket. Take the pan out, let the unit cool down.
Wipe the walls of the baking chamber and the heating
element with a wet cloth
When making bread according to the chosen recipe switch
the unit off right after the bread is ready
Grease the paddle with oil before assembly
Press the «Start/Stop/Pause» button to launch the
program
Wait until the program starts.
Contact the customer service
Remove hard objects and the crumbs from the pan (5)
Remove the paddle and install it properly on the axle
ENGLISH