Endress+Hauser iTEMP TMT82 Betriebsanleitung Seite 32

®
Transmitter via HART -Protokoll einbinden
32
Kommando-Nr. Bezeichnung
1, Cmd001 Read primary variable
2, Cmd002 Read loop current and percent of range
3, Cmd003 Read dynamic variables and loop current
6, Cmd006 Write polling address
7, Cmd007 Read loop configuration
8, Cmd008 Read dynamic variable classifications
9, Cmd009 Read device variables with status
11, Cmd011 Read unique identifier associated with TAG
12, Cmd012 Read message
13, Cmd013 Read TAG, descriptor, date
14, Cmd014 Read primary variable transducer information
15, Cmd015 Read device information
16, Cmd016 Read final assembly number
17, Cmd017 Write message
18, Cmd018 Write TAG, descriptor, date
19, Cmd019 Write final assembly number
20, Cmd020 Read long TAG (32-byte TAG)
21, Cmd021 Read unique identifier associated with long TAG
22, Cmd022 Write long TAG (32-byte TAG)
38, Cmd038 Reset configuration changed flag
48, Cmd048 Read additional device status
Common practice commands
33, Cmd033 Read device variables
34, Cmd034 Write primary variable damping value
35, Cmd035 Write primary variable range values
36, Cmd036 Set primary variable upper range value
37, Cmd037 Set primary variable lower range value
40, Cmd040 Enter/Exit fixed current mode
42, Cmd042 Perform device reset
44, Cmd044 Write primary variable units
45, Cmd045 Trim loop current zero
46, Cmd046 Trim loop current gain
50, Cmd050 Read dynamic variable assignments
51, Cmd051 Write dynamic variable assignments
54, Cmd054 Read device variable information
59, Cmd059 Write number of response preambles
103, Cmd103 Write burst period
104, Cmd104 Write burst trigger
105, Cmd105 Read burst mode configuration
107, Cmd107 Write burst device variables
108, Cmd108 Write burst mode command number
109, Cmd109 Burst mode control
iTEMP TMT82
Endress+Hauser