Agilent Technologies Turbo-V 2000HT Betriebsanleitung Seite 73

USE PROCEDURE
Controller Startup
To startup the controller plug the power cable into a
suitable power source and set the line main switch to
the position I.
Starting the pump
To start the pump press the START push-button on the
controller front panel.
Pump Shutdown
To shutdown the pump press the STOP push-button on
the controller front panel.
MAINTENANCE
The Turbo-V 2000HT series controller does not require
any maintenance. Any work performed on the controller
must be carried out by authorized personnel.
When a fault has occurred it is possible to use the
Varian repair service. Replacement controllers are
available on an advance exchange basis through
Varian.
!
Before carrying out any work on the controller,
disconnect it from the supply.
Controller 969-9462 and 969-9562 rear panel
WARNING!
1. Logic input signals connectors
supplied with link).
2. Pump current and frequency logic and control signals
output connector.
3. RS 232, RS 422 and RS 485 (provided as option) serial
communication port connector slot.
4. Pump connector.
5. Main breaker switch.
6. Power cord.
7. Power output connector (120 Vac, 1A) to power the pump
fan and the optional devices (vent device, primary pump
activation relay, etc.).
If a pump is to be scrapped, it must be disposed off in
accordance with the specific national standards.
Meaning of the "WEEE" logo found in labels
The following symbol is applied in accordance with the
EC WEEE (Waste Electrical and Electronic Equipment)
Directive.
This symbol (valid only in countries of the European
Community) indicates that the product it applies to
must NOT be disposed of together with ordinary
domestic or industrial waste but must be sent to a
differentiated waste collection system.
The end user is therefore invited to contact the supplier
of the device, whether the Parent Company or a
retailer, to initiate the collection and disposal process
after checking the contractual terms and conditions of
sale.
67
INSTRUCTIONS FOR USE
(mating connector
DISPOSAL
87-900-913-01 (N)