Bauer T2 Bedienungsanleitung Seite 7

Connecting
Details of the correct power supply (AC
voltage, mains frequency)
the type plate underneath the projector.
If your model
several voltages,
voltage at selector 13.
Connect the
and plug the projector.
Projector Control
(Fig. A)
Switch Turned to Right (Clockwise)
Film projection.
Switch Turned to Left (Anticlockwise)
Rapid rewind,
Aligning the Projector
Turn control
align the projected image on the screen:
The picture size is adjusted by turning
the knurled
alter the height
screen, turn
rectly aligned,
to O.
Preparing the Film
A leader approx. 50 cm (20 in) long
should be spliced
film. The end of the film
4
as shown in Fig. B. Make sure
the first 10 cm
are straight
Select Film
Set selector
8 (N 8) or super
Loading the Projector
Unfold the front spool arm 6. Place the
film spool on the spool arm shaft. Pla•
ce the empty spool on
shaft I.
To thread the film
trol switch 2 to the right and insert the
end of the film into the threading aper-
ture 11 until the claw begins to draw
to Power Supply
are given on
is designed to
select the local
mains lead to socket
Switch Functions
bulb switched off.
switch 2 to the right
ring on zoom lens 10. To
of the image on the
knurled wheel 9. When
return control switch
to the start
should
(4 in) of the
and undamaged.
Format
switch 5 to either
8 (S 8).
rear spool
(Fig. C), turn
in the
automatically
nected to the empty spool.
Adjust image focus at rotary knob 7. if
the line dividing two frames of the film
run on
is visible
mains
until the frame line disappears.
12
Slow
While projecting
be operated to reduce projection speed
to 9 frames
then be projected in slow motion without
the image on the screen flickering.
To repeat a scene just
control
length of film can then be rewound quick-
ly through the film gate.
At the end of the film, turn control switch
2 to
Removing
Projection
Move
and
the knob.
Carefully
(Fig.
from the film gate.
cor-
2
Rewinding
The film can be rewound in two ways:
if the trailer
long enough, turn control switch 2 past
the O setting to the left at the end of
of the
the film;
be cut
through the gate.
that
If the film has already passed comple.
leader
tely through the projector,
of the film back over the lamp housing
cover and attach to the front spool by
hand. Turn
and the film
Standard front spool.
Care
Changing the Projector Bulb
First disconnect
mains power supply. Pull off control switch
2 and take off bulb housing cover 3.
con-
Allow
cool, then turn
remove.
Insert the new projector bulb (8 volt /
film. The film will
through the gate and con-
on the screen,
Motion
the film, switch 8 can
per second. The film will
switch 2 to the left. The desired
O.
a Film from the Gate during
control switch 2
to O and pull off
Take off bulb
housing cover 3.
pull out film
pressure
D). The film can
now
at the end of the film
the film will then be rewound
control switch
will be rewound
and Maintenance
the projector from the
projector bulb 14 (Figs. D.E) to
gently to the left and
be threaded
move lever 4
projected, turn
pad 15
be removed
is
run the end
2 to the left
onto the
5