Benelli TRK502 2019 Bedienungsanleitung Seite 130

Auxiliary USB jack
WARNING
To prevent electrical shock or short-circu-
iting, make sure that the cap is installed
when the auxiliary (USB) jack is not being
used.
NOTICE
The accessory connected to the auxiliary
USB jack should not be used with the en-
gine turned off, and the load must never
exceed 24 W (2A), otherwise the fuse may
blow or the battery may discharge.
This vehicle is equipped with an auxiliary USB
jack.
A 12-V accessory connected to the auxiliary
USB jack can be used when the key is in the
" " position and should only be used when
the engine is running.
To use the auxiliary USB jack
1. Turn the key to " ".
2. Remove the auxiliary USB jack cap.
1. Auxiliary USB jack cap
3. Turn the accessory off.
4. Insert the accessory plug into the auxiliary
USB jack.
1
1. Auxiliary USB jack
5. Turn the key to " ", and then start the engi-
ne. (See page 5-1.)
6. Turn the accessory on.
3 - 19
Instrument and control functions
1
EN
3