HomeMatic HM-Sec-Key Montage- Und Bedienungsanleitung Seite 23

Start-up
6.3.2 Deleting taught-in remote controls
To delete a taught-in remote control, proceed as follows:
• Press the bottom button "Lock" (F) for approx. 2 seconds.
Another long press of the button "Lock" (press button for approx. 2 seconds)
ends the deletion procedure, without deleting a memory location (e.g. if the
button has been actuated accidentally). If no button actuation occurs for 3
minutes after calling the menu, the menu is exited automatically without
deleting a memory location.
The LC display shows "X", the symbols for radio reception and "Lock" flash.
• Now, take the "Master" remote control and press any button (button must be
already assigned to the KeyMatic) until the "X" disappears and the first
memory location appears.
• Select the memory location to be deleted, e.g. "3" on the door lock drive with
the button "Lock" or "Unlock".
• In order to delete the selected memory location, briefly press the small
"Setup" (C) button on the door lock drive.
• When the deletion is successful, the menu is exited with three short tone
signals.
The door lock drive can no longer be operated with the deleted remote control.
If a lost or stolen remote control is found again, it can be taught-in to the door
lock drive as described in sec. „6.3.1 Teaching-in remote controls and buttons"
on page 42. Since copying the remote control is not possible, there is no
reason not to continue using it as usual.
Only the occupied memory slots are shown when deleting. If no remote controls
have been taught-in (factory status) or only the "Master" remote control is
taught-in, the display shows the message "M". Deleting the "Master" remote
control (memory location "1") is not possible here.
44
6.3.3 Teaching-in to the HomeMatic Central Control Unit
Please read this entire section before starting the teach-in procedure!
Your device can be conveniently
• controlled and configured,
• connected directly to other devices or
• used in central control unit programs
by using the HomeMatic software "WebUI". Therefore, your door lock actuator has to be
taught-in to the HomeMatic Central Control Unit first. New devices are taught-in to the
central control unit via the HomeMatic „WebUI".
As soon as a device has been taught-in to a central control unit, it can only be
connected to other components via this unit.
Each device can be taught-in to one central control unit only.
During teach-in, please make sure you maintain a distance of at least 50 cm
between the HomeMatic devices and the central control unit.
To teach-in your device to the central control unit, proceed as follows:
• Open the "WebUI" user interface in your browser.
• Click the "Teach-in devices" button on the right-hand side of the screen.
Fig. 11: Screenshot teach-in devices
• To activate teach-in mode, click "Start teach-in mode".
Start-up
45