Scheppach NTS16 Originalbetriebsanleitung Seite 21

Wet vacuuming
Use the foam filter (13) for wet vacuuming. Ensure that
the foam filter (13) is correctly fitted.
If the container (6) is full, the safety float valve (11) clo-
ses the suction port and suction operation is interrup-
ted.
m IMPORTANT!
The device is not suitable for vacuuming flammable li-
quids. For wet vacuuming, use the only the foam filter
(14) provided. To remove the liquid vacuumed up from
the container, take off the machine head (2) by relea-
sing the locking hooks (4) from the container (6). Pour
out the liquid residue.
9. Maintenance and cleaning
m WARNING!
Prior to any adjustment, maintenance or service work
disconnect the mains power plug!
Cleaning
It is recommended to clean the device after each use.
Do not spray the device with water or clean it under
running water. This can result in electric shocks and
can damage the device.
Residual liquid remains in the container (6). To remove
residual liquid, take off the machine head (2) by relea-
sing the locking hooks (4) from the container (6). Pour
out the liquid residue. Clean the container with a damp
cloth.
• Replace paper filter bag when full
• Always keep the device clean. Do not use cleaning
agents or solvents.
• Keep the ventilation slots clean and free of dirt and
dust.
• Clean the device only with a soft brush or a damp
cloth.
• Clean the foam filter (13) with a little soap and run-
ning water and then leave it to air dry.
Maintenance
The device is maintenance-free.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consuma-
bles.
Wear parts: Foam filter, Paper filter bag,
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
10. Storage
Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.
Storage (fig. 1, 11)
• Wind the connection cable (3) around the machine
head (2) and lay it in the top cable holder (9).
• The remaining accessories can be stored in the con-
tainer (6).
11. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions.
The customer's mains connection as well as the
extension cable used must also comply with the-
se regulations.
Important information
In the event of an overloading the motor will switch
itself off. After a cool-down period (time varies) the
motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Passage points, where connection cables are pas-
sed through windows or doors.
• Kinks where the connection cable has been impro-
perly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
www.scheppach.com GB | 21