Vitek VT-1202 Red Bedienungsanleitung Seite 8

Cleaning of the steam chamber
To extend the life of the iron it is recommended
to perform regular cleaning of the steam cham-
ber, especially in areas with hard tap water.
− Set the constant supply of steam (4) to «
(steam off).
− Fill the container (10) water to the «MAX»
mark (12).
− Put the iron on the base (8).
− Plug the power cord into an outlet.
− Turn the regulator(9) set the maximum heat-
ing temperature of the soleplate «MAX», the
indicator lights (6).
− When the soleplate (13) warms up to temper-
ature, the indicator (6) disappears. Wait for
reheating of the soleplate, after that you can
clean the steam chamber.
− Remove the plug from the socket.
− Place the iron horizontally above the sink, press
and hold the «SELF-CLEAN» button (11).
− Boiling water and steam along with the scum
will be coming out of the holes of soleplate (13).
− Slightly shake the iron forward and back until
all the water will come from a reservoir (10).
− Put the iron on the base (8) and let it become
completely cool.
− When the soleplate (13) is completely cool,
wipe it with a piece of dry cloth.
− Before removing iron, make sure that there
is no water in the tank (10)and the soleplate
(13) is dry.
Care and Cleaning
− Before cleaning the iron, make sure it is un-
plugged and has cooled down.
− Clean the iron trunk with a slightly damp
cloth, then it should be wiped with a dry one.
− The deposits on the soleplate can be re-
moved with a cloth dampened in water and
vinegar solution.
− After removing of sediment, polish the sur-
face with a dry cloth.
− Do not clean the soleplate and body of the
iron with abrasives.
− Avoid contact of the iron soleplate with sharp
metal objects.
− Depending on water hardness in your area,
change the water softener cartridge periodi-
cally (14). To remove the cartridge, open the
filler (2), turn the cartridge (14) counterclock-
1202.indd 7 1202.indd 7
wise and pull it upward (Fig. 7).
− Install a new cartridge, then turn it clockwise
to lock and close the filler (Fig. 8.
»
Storage
− Set the temperature (9) to «MIN» position,
and the constant control of steam (4) to «
(steam off).
− Remove the plug from the socket.
− Open the lid of filler (2), turn the iron and
drain the remaining water from the water tank
(10) (Fig. 6).
− Close the lid of(2).
− Set iron on its heel and let it become com-
pletely cool.
− Roll up the power cord of the iron.
− Keep the iron upright in a cool, dry place in-
accessible to children.
Delivery set
Iron - 1 item
Cartridge - 1 item
Measuring cup - 1 item
Manual - 1 item
Technical characteristics
Power supply: 220-240 V
Consumption power: 2020–2400 W
Water tank: 400 ml
Life span of the iron - 3 years
The manufacturer preserves the right to change
the design and specifications of the unit without
a preliminary notification.
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-Re-
quirements as laid down by the Council
Directive 89/336/EEC and to the Low
Voltage Regulation (73/23 EEC)
7
ENGLISH
»
50/60 Hz
~
20.09.2011 12:34:57 20.09.2011 12:34:57