Endress+Hauser Proline Promag W 400 Einbauanleitung Seite 22

EA01090D
8.4 Mounting the wall-mount housing
8.4.1 Ambient temperature too high!
NOTICE
Danger of overheating!
Danger of electronics overheating and housing deformation.
‣
Do not exceed the permitted maximum ambient temperature.
‣
If operating outdoors: Avoid direct sunlight and exposure to weathering, particularly in
warm climatic regions.
‣
Excessive strain can damage the housing! Avoid excessive mechanical stress.
For detailed information on mounting on a post, see the "Post-mounting" section of the
Operating Instructions for the device.
17 (0.67)
1. Drill the holes. 2. Insert wall plugs into the drilled holes. 3. Screw the securing screws in slightly. 4.
Fit the transmitter housing over the securing screws and hook into place.
5. Tighten the securing screws.
For detailed information on the electrical connection, see the "Electrical connection"
section of the Operating Instructions for the device.
For detailed information on commissioning, see the "Commissioning" section of the
Operating Instructions for the device.
22
14 (0.55)
5.8 (0.23)
5.8 (0.23)
= =
149 (5.85)
Endress+Hauser