Endress+Hauser Proline Promag W 400 Einbauanleitung Seite 19

8.2 Reassembling the transmitter (remote version)
Version A: If a grounding switch is provided on the ISEM module:
Set the grounding switch of the ISEM electronics module to the position on the "right"
(open), as illustrated in the diagram below.
1
Version B: If a jumper is provided on the ISEM module:
Set the jumper grounding setting on the ISEM electronics module so that it is pointing
outwards (open), as illustrated in the diagram below.
1
Endress+Hauser
EA01090D
19