SystemAir SAVE VTR 150/B R 500W Betriebs- Und Wartungsanleitung Seite 29

24
| Installation
1. Install four M6 bolts into threaded inserts in brackets and lock bolts with hex nuts (figure 14). Bolts protrusion can be
adjusted later.
A cross screwdriver and a 10 mm spanner are needed. They are not included in the package.
Brackets are adjustable vertically (figure 14, A) and horizontally (figure 14, B). Align the brackets with the underside
of the unit. Fully tighten screws after adjusting the brackets.
2. Install four hooks near the edges on the kitchen furniture panel. Sticker with marked holes (figure 15, pos. 1) is in-
cluded with the unit. Holes mark spots for screws to attach hooks. Place the sticker on a back of the kitchen furniture
panel, figure 15, pos. 2). Size of the sticker is the same as the unit. Manually mark out distances from the edges in
case the panel is bigger than the sticker.
Once correct position is found, attach four hooks (figure 15, pos. 3) by fastening each with two screws (figure 15,
pos. 4). Hang the panel on protruding bolts (figure 15, pos. A).
If the kitchen furniture panel does not align with cabinets, take it off and adjust bolts, brackets or hooks.
Fig. 14 Installation of bolts and brackets
Fig. 15 Installation of hooks and mounting of the cover
GB
212024 | A003, rev 29