Werbung
Verfügbare Sprachen
Verfügbare Sprachen
22
| Installation
6.3.3.1 Wiring and configuration
Connect and configure control signal from the cooker
hood to the unit.
Installation and connection
1. Connect control signal wires from the cooker hood to
any free universal input and 24 V on the external con-
nection board (figure 7). For more information about
connection board see 8.2 External connections (Con-
nection board), page 48.
Note:
Configuration of the Cooker Hood Function
can be done only after the first power up of
the SAVE VTR 150/B unit and competed
startup wizard.
Configuration
1. Go to Service menu
2. Enter password (default 1111)
3. Go to Input menu. Select UNIVERSAL tab.
4. Select the universal input to which the cooker hood is connected. Example if it is connected to UI1 on the connection
board, then select UNIVERSAL INPUT 1. Set signal type as Digital input and select an option Cooker Hood
Function from the input type list.
Important
Make sure configuration is logged in the commissioning record!
6.4
Installation of a kitchen furniture panel
The kitchen furniture panel can be mounted directly on the unit, sides of cabinets or installed as a door. Parts for panel
installation directly on the unit and sides are delivered with the unit.
6.4.1
Mounting the kitchen furniture panel directly on the unit
Depending on the kitchen cupboard depth, the unit might
have to be shifted forward for the panel to be aligned
with the cupboards.
Number
Explanation
1
Wall or any other mounting surface
2
Wood block (if needed, 25–100 mm)
3
SAVE VTR 150/B
4
Adjustable bolts (15–25 mm)
5
Kitchen furniture panel (P)
Adjust bolts if shifting distance is less than 25 mm or use wood blocks in case the required distance is greater.
Fig. 7 Connection of the cooker hood
Fig. 8 Top view
GB
212024 | A003, rev 29
Werbung
