Unit Mounting And Cooker Hood Wiring - Systemair Save Vtr 150/B R 500W Betriebs- Und Wartungsanleitung

GB
2. Attach the brackets as far into the cooker hood as pos-
sible. Insert the cooker hood up into the hole in the
base of the cupboard. Pull out (figure 5, pos. A) and use
screws to fasten the brackets to the sides of the cup-
board (figure 5, pos. B). Tighten the brackets in the
cooker hood.
6.3.3

Unit mounting and cooker hood wiring

Mounting the unit with attached cooker hood
1. Pull the cooker hood power supply and control cables
to the top since the mounted SAVE VTR 150/B unit will
block access to the back.
2. Once all cooker hood cables at the back are led to the
top, lift the unit and hang it on the mounting bracket.
Warning
Beware of sharp edges during mounting
and maintenance. Use protective gloves.
Consider the unit weight when mounting!
Note:
Make sure that the unit is completely vertical and horizontal once mounted on the wall. Check with a spirit
level.
Make sure there is at least 2 mm gap between the unit and the cupboard to prevent vibration noises.
Mounting the unit with the cooker hood installed using brackets
1. Pull the cooker hood power supply and control cables to the top since the mounted SAVE VTR 150/B unit will block
access to the back.
2. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
3. Connect the cooker hood and the SAVE VTR 150/B unit using flexible duct.
212024 | A003, rev 29
Fig. 5 Installation using brackets
Fig. 6 Placing the unit on the mounting bracket
21
Installation |