Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
In case the depth of cabinets is much greater than the unit, install wooden blocks (pos. W) to compensate the missing
distance (figure 9, pos. B). Then install the mounting bracket on the upper block. Choose thickness of blocks according
to your needs.
Thickness of wooden blocks should be 25–100 mm. If needed distance is lower than 25 mm, adjust bolts instead of us-
ing wooden blocks (see figure 12).
Caution
Be sure to select the appropriate type and length of the screws so that they could hold additional wood
blocks and the unit itself.
6.3.2
392–10/B cooker hood installation
Product name and number
• 392-10/B Slimline — 77265
The cooker hood must be attached to the sides of cupboards or directly to the SAVE VTR 150/B unit first before it can
be mounted on the wall because cooker hood power supply and control cables at the back must be led to the top and
already mounted SAVE VTR 150/B unit will block access.
There are two options how to install the cooker hood:
• The cooker hood is attached directly to the bottom of the unit. This option can be used when the whole unit with a
cooker hood will be shifted forward using wood blocks to be alighted with the cupboards or when the cupboard size
matches the unit and no adjustments are needed. This way the unit can be simply mounted directly on the wall with
already attached cooker hood.
• The cooker hood is attached to the sides of cupboards using included brackets. If the unit and cooker hood is not
aligned, a flexible duct must be used since it will be impossible to insert the cooker hood directly into the unit.
Follow instructions in the manual delivered with the cooker hood.
6.3.2.1 Installation between or in a cupboard without a base with a cooker hood attached
directly to the unit
1. Remove the cooker hood filter to access holes at the
top of the cooker hood from inside.
Insert included screws (figure 4, pos. 2) into the cooker
hood holes, place included plastic spacers on the each
protruding screw to prevent over-tightening (figure 4,
pos. 3).
2. Place a circular insulation on the cooker hood connector
to prevent air leaking (figure 4, pos. 4).
3. Insert the cooker hood duct connector into the unit and
tighten the screws.
Screw the cooker hood directly to the bottom of the
unit using prepared holes (figure 4, pos. 1).
6.3.2.2 Installation between or in a cupboard without a base using brackets
When the cooker hood cannot be attached directly to the unit, use included brackets. Flexible duct is needed to connect
the cooker hood with the SAVE VTR 150/B unit when using this type of installation.
1.
212024 | A003, rev 29
Fig. 4 Attaching the cooker hood directly to the unit
19
Installation |
Werbung
