Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem and alarm code
The remaining time in the display
increases and skips nearly to the
end of the programme duration.
Small leak from the appliance
door.
The appliance door is difficult to
close.
The appliance door opens during
the wash cycle.
Rattling or knocking sounds from
the inside of the appliance.
The appliance trips the circuit-
beaker.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
WARNING!
We do not recommend using the
appliance until the problem has been
completely fixed. Unplug the appliance
and do not plug it in again until you are
certain that it operates correctly.
12.1 The product number code (PNC)
If you contact an Authorised Service Centre,
you need to provide the product number code
of your appliance.
Possible cause and solution
•
This is not a defect. The appliance is working correctly.
•
The appliance is not levelled. Loosen or tighten the adjustable feet
(if applicable).
•
The appliance door is not centred on the tub. Adjust the rear foot (if
applicable).
•
The appliance is not levelled. Loosen or tighten the adjustable feet
(if applicable).
•
Parts of the tableware are protruding from the baskets.
•
The AirDry function is activated. You can deactivate the function.
"Basic settings"
Refer to
•
The tableware is not properly arranged in the baskets. Refer to bas‐
ket loading leaflet.
•
Make sure that the spray arms can rotate freely.
•
The amperage is insufficient to supply simultaneously all the appli‐
ances in use. Check the socket amperage and the capacity of the
meter or turn off one of the appliances in use.
•
Internal electrical fault of the appliance. Contact an Authorised Serv‐
ice Centre.
The PNC can be found on the rating plate on
the appliance door. You can also check the
PNC on the control panel.
Before checking the PNC, make sure the
appliance is in the programme selection.
1. Press and hold simultaneously Glass
care and AUTO for about 3 seconds.
The display shows the PNC of your
appliance.
2. To exit the PNC presentation, press and
hold simultaneously Glass care and
AUTO for about 3 seconds.
The appliance returns to the programme
selection.
.
ENGLISH
25
Werbung
