JUNO JGVX608E2 Benutzerinformation Seite 12

setting, a dedicated letter is displayed. The
dedicated letters are indicated in the table.
The order of the basic settings presented in
the table is also the order of the settings in
setting mode.
7.1 Setting mode
How to enter setting mode
You can enter setting mode before starting a
programme. You cannot enter setting mode
while the programme is running.
To enter setting mode, press and hold
simultaneously 30min and ECO for about 3
seconds.
• The lights related to 60min, 90min
and Intensive are on.
• The display shows the current value of
the first available setting.
How to navigate in setting mode
You can navigate in setting mode using
programme buttons.
A B
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch between
the basic settings and to change their value.
Use OK to enter the selected setting and to
confirm changing its value.
Water hardness
German French de‐
degrees grees (°fH)
(°dH)
47 - 50
43 - 46
37 - 42
12 ENGLISH
C
mmol/l
84 - 90 8.4 - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
How to change a setting
Make sure the appliance is in setting mode.
1. Use Previous or Next to select the
desired setting.
The display shows the current setting value
(a digit and the dedicated letter).
2. Press OK to enter the setting.
The current setting value flashes.
3. Press Previous or Next to change the
value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
5. Press and hold simultaneously 30min
and ECO for about 3 seconds to exit
setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
7.2 The water softener
The water softener removes minerals from
the water supply, which would have a
negative effect on the washing results and on
the appliance.
The higher the content of these minerals, the
harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in your
area. Your local water authority can advise
you on the hardness of the water in your
area. Set the right level of the water softener
to assure good washing results.
mg/l (ppm) Clarke
degrees
835 - 904 58 - 63
755 - 834 53 - 57
645 - 754 46 - 52
Water soften‐
er level
10
9
8