Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOTICE! Adjust the doors properly before you finally tighten the screws of
the hinges. The seals must close properly.
Empty the appliance.
If possible, remove all door trays, glass shelves and drawer from the fridge /
freezer so that they cannot be damaged.
It is necessary to tilt the appliance backwards while removing the doors. You
should rest the appliance on something solid so it will not slip while changing the
hinge positions.
Do not lay the unit flat as this can damage the cooling system.
All parts removed must be saved for proper reinstallation of the doors.
Always remove the doors carefully. Keep the doors in a safe place so that they
cannot be damaged.
1. Unscrew the right upper hinge and remove it.
It may be necessary to remove the cover of the hinge previously (depending on model).
2. Lift the upper door and remove it carefully.
3. Unscrew the right middle hinge and remove it.
4. Lift the lower door and remove it carefully.
5. Unscrew the right bottom hinge and remove it.
It may be necessary to unscrew the adjustable feet previously (depending on model).
6. Remove the hole covers from the left bottom side of the appliance and reinsert them on the right side
(depending on model).
7. Align the bottom hinge to the prepared holes on the left side properly and screw it tightly.
It may be necessary to turn the bottom hinge through 180
properly (depending on model).
It may be necessary to unscrew the adjustable feet previously (depending on model).
8. Remove the hole covers from the left middle side of the appliance and reinsert them on the right side.
9. Attach the lower door to the bottom hinge carefully and hold the door in position.
10. Align the middle hinge to the prepared holes on the left side properly and screw it tightly. Ensure
that the lower door is fixed safely and properly by the hinges.
It may be necessary to turn the middle hinge through 180
properly (depending on model).
P
REPARATORY MEASURES
C
HANGE OF THE HINGE POSITION
54
:
:
to align it to the prepared holes
0
to align it to the prepared holes
0
Werbung
