Carl Valentin Dynacode 53 Kurzanleitung Seite 115

Service Functions
NOTICE!
So that the distributor res. the manufacturer in case of service can offer fast support the necessary information such
as selected parameters can be taken directly from the service functions menu of the device.
Keys: , , ,
Key:
Key:
Key:
Key:
Key:
Key:
Key:
Key:
, , , ,
Photocell parameters:
H = cover switch (0 = open cover; 1 = closed cover).
P = compressed air control
Value range: 0 or 1.
R1 = transfer ribbon rewinding roll
Indication of transfer ribbon rewinding roll status.
4 states are indicated (no marking in photocell, marking from right, marking from left, marking
completely in photocell).
R2 = transfer ribbon unwinding roll
Indication of transfer ribbon unwinding roll status.
4 states are indicated (no marking in photocell, marking from right, marking from left, marking
completely in photocell).
C = Carriage: Indication of print carriage position.
ENC = Encoder: Indication of current state of encoder
Paper counter:
D: Indication of printhead attainment in meters.
G: Indication of module attainment in meters.
Heater resistance:
To achieve a high print quality, the indicated Ohm value must be set after replacing the
printhead.
Printhead temperature:
Indication of printhead temperature. The printhead temperature corresponds normally to the
room temperature. In case the maximum printhead temperature is exceeded, the current print
order is interrupted and an error message appears at the modules display.
Ribbon / Ink side:
Ribbon: Selection of the used transfer ribbon length (300 m, 450 m, 600 m, 900 m, 1000 m).
With smaller ribbons, a higher number of cycles can be reached.
Ink side:
Selection of the coating side of transfer ribbon, either outside or inside.
Default: Coating outside
BrkPow:
Adjustment of brake power for acceleration and braking in %.
BrkPowP:
Adjustment of brake power during printing.
Print examples:
Settings: Printout of all settings such as speed, and transfer ribbon material.
Bar codes: Printout of all available bar code types.
Fonts: Printout of all available font types.
Input/Output:
Indication of signal level which indicates the signal a print order is started.
0 – Low
1 – High
English
, , , ,
Dynacode
115