Carl Valentin Dynacode 53 Kurzanleitung Seite 112

Dynacode
Key:
I/O Parameters
Keys: , , ,
Key:
Key:
Key:
Key:
Key:
Key:
Network
Keys: , , ,
For more information, please see the separate manual.
112
Standard layout:
On: If a print order is started without previous definition of layout, the standard layout (device
type, firmware version, build version) is printed.
Off: If a print order is started without previous definition of layout, an error message appears in
the display.
, ,
IN signal level:
Indication of signal at which a print order is started.
+ = active signal level is 'high) (1)
− = active signal level is 'low' (0)
x = not activated signal level
s = status can be affected by interface (in combination with Netstar PLUS)
OUT signal level:
Indication of signal level for output signal.
+ = active signal level is 'high) (1)
− = active signal level is 'low' (0)
s = status can be affected by interface (in combination with Netstar PLUS)
Debounce
Indication of debounce time of the dispenser input.
Value range: 0 ... 100 ms.
Start signal delay:
Indication in time per second of the delay for the start signal.
Value range: 0.00 ... 9.99.
Error if not ready:
On: If a print order is active but the direct print module is not ready to process the order (e.g. if
it is already in 'printing' mode), then an error message appears.
Off: No error message appears.
Ready while printing:
Indication if the output signal 'print ready' (Out 5, Output II) remains active while printing.
Off: At print start the 'print ready' signal is inactive (default setting).
On: At print start the 'print ready' signal remains active.
, , ,
English