Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning the power heads
Maintaining the power head
Perform maintenance when suction power is weak or when dirt becomes a concern.
We recommend periodic maintenance (about once a month).
Dust and debris stuck to the safety switch, rotary brush, brushes, wheels, air inlet, and rotating sections
might cause reductions in suction power or malfunctions.
Risk of injury
CAUTION
Before performing maintenance, detach the power head from the vacuum cleaner or extension
pipe and smart hose.
Remove attached dust and debris
Remove the attached dust and debris by using the 2-way crevice nozzle or other tools.
2-way crevice nozzle
Rotating sections
Remove tangled dust and debris
Remove tangled dust and debris using tweezers, etc.
Tweezers
Wheels
Rotary brush
Risk of damage to the floor
If dust and debris gets tangled in the wheels, the wheels cannot rotate, which might cause
wear and tear and floor damage.
CAUTION
After extended use, the brushes, wheels, and rotary brush might wear down. Using the power
head while they are worn out might damage the floor. You cannot replace the brushes or
wheels by yourself. Please contact a Hitachi authorized service agent to have the brushes,
wheels, and rotary brush replaced as a set.
Note
Do not subject the safety switch to excessive force. Failure to do so might cause damage.
Rotating sections
Air inlet
Brushes
Remove dust and
debris tangled in the
shaft using tweezers
Safety
switch
or other tools.
Remove dust and
debris tangled in the
rotary brush by using
scissors or other tools.
2-way crevice nozzle
Wheels
Rotary brush
Wheels
Scissors
Safety switch
Brushes
Tweezers
Shafts
EN-35
Werbung
