Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning the filters
Clean filter
Open the clean filter.
Set the dust case on the
floor.
Remove dust and debris from the clean filter.
Detach the clean filter.
Sponge filter
Wash the sponge
filter with water if
there is dirt on the
→
filter.
(P.EN-33)
Perform maintenance (wash with water) when you are concerned about dirt or the suction power is weak.
Attach the clean filter.
Attach the clean filter in the
reverse order of removal.
Close the clean filter.
Press firmly until you hear a "click"
sound.
Note
Make sure the sponge
filter is attached.
Grab and hold the lower part of the dust case, lift up the
knobs of the clean filter, and open the cover in the direction
indicated by the arrow.
Dust case
Clean filter
Note
When removing dust and debris, do not slap the clean filter
onto the floor, etc. Failure to do so might cause damage.
Be sure to attach the sponge filter after emptying the
dust case or cleaning the filters.
To clean the clean filter, use the maintenance brush that
was provided with the vacuum cleaner.
Clean filter
Clean filter
Knobs
Remove attached dust and debris by using
the maintenance brush.
Maintenance brush
Detach
Click
Clean filter
→
(P.EN-33)
Attach
EN-29
Werbung
