Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Controls and indicators
Control buttons
To operate
Press the
button.
Each time the button is pressed, the
operation status will be the order of
→
→
"standard"
"high"
"turbo"
"standard"... is switched.
Press 1
for normal cleaning
st
Press 2
for careful carpet cleaning
nd
Press 3
for powerful cleaning in heavily
rd
dirty areas.
Indicator during charging
Battery
indicator
Do not touch the terminals on the AC adapter or vacuum cleaner.
Failure to heed this warning might cause electric shock or injury.
WARNING
Do not charge the vacuum cleaner if the battery is not attached.
Failure to heed this warning might cause malfunction or electric shock.
Do not remove the battery while the vacuum cleaner is being charged.
Note
→
Battery Indicator
On
Off
If the battery indicator blinks rapidly (about four times per second), this
indicates an abnormality with the AC adapter or the battery. → (P.EN-42)
If you remove the vacuum cleaner from the charging station (or
disconnect the AC adapter) after the battery indicator turns off, and then
set the vacuum cleaner back onto the charging station,
the battery indicator turns on, but this does not indicate a problem with
the vacuum cleaner.
If you remove the battery while charging, after a short time, the indicator
blinks (about four times per second). If this happens, remove the
vacuum cleaner from the charging station (or disconnect the AC
adapter) and then attach the battery back onto the vacuum cleaner.
Then, set the vacuum cleaner back onto the charging station or
reconnect the AC adapter.
To automatic operation
Press the
button.
The sensor will sense the type or state of
the floor, as well as the operation mode of
the electric suction head, and automatically
switch between "standard" and "High"
operation.
To Stop operation
Press the
button.
Charging status
The battery is charging.
Charge time is approx. 2.5 hours. Depending
On the ambient temperature, usage time, etc,
if the battery's temperature is very hot,
charging may automatically go into standby
until the temperature lowers to an
appropriate temperature for charging,
causing the charging time to increase. →
(P.EN-42)
The battery is fully charged.
When the battery is fully charged, the battery
indicator turns off.
EN-15
Werbung
