Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10 Operation
10.1 Function check
After power-on the device is in the operating mode� It carries out its measurement
and evaluation functions and generates output signals according to the set
parameters�
► Check whether the unit operates reliably�
10.2 Operating and diagnostic messages via IO-Link
IODD and IODD descriptive text as a pdf file at: → www.autosen.com
10.3 Operating indication by LEDs
The following indications refer to the factory settings� In this state OUT1 = Hno
and OUT2 = Hnc�
Both yellow LEDs (LED1 and LED2, → 8) indicate the switching status of output
OUT1�
Operating status
Unit ready for operation, no medium
detected
Unit ready for operation, medium
detected
No operating voltage / operating voltage
too low
Short circuit OUT1
Short circuit OUT2
Error / failure
Visual indication for localisation
Teach operation
Fault during the teach operation
Teach with locked unit (→ 9.1.1)
X: according to level
LED1
LED2
(yellow)
(yellow)
(OUT1)
(OUT1)
OFF
OFF
ON
ON
OFF
OFF
flashes at 4 Hz
flashes at 4 Hz
OFF
OFF
1 Hz double flashing
(→ 9.1)
8 Hz yellow/green flashing for 2 s
X
LED3
(green)
(Operating
voltage)
ON
ON
OFF
ON
ON
flashes at
8 Hz
ON
X
flashes at
1 Hz
UK
41
Werbung
