autosen AF007 Betriebsanleitung Seite 29

5.3 Features of the unit
• Point level selectable by the installation length (→ 6).
• Parameter setting using the teach button (→ 9.1) or via IO-Link (→ 9.2).
• The unit has two switching outputs:
- Output OUT1 is assigned to the process value "Level"�
- Output OUT2 can be assigned to the process value "Level" or "Temperature"�
• Adjustment function (empty and full adjustment) to the medium to be detected�
• Defined state in case of a fault (→ 9.2.4)
5.3.1 IO-Link
The device has an IO-Link communication interface which requires an IO-Link
capable module (IO-Link master)�
The IO-Link interface enables direct access to the process and diagnostic data
and provides the possibility to set the parameters of the unit during operation�
The IODDs necessary for the configuration of the unit, detailed information about
process data structure, diagnostic information, parameter addresses and the
necessary information about the required IO-Link hardware and software can be
found at www�autosen�com�
5.4 Application examples
1
1: Overflow protection in a supply tank for coolant emulsion�
2: Leakage monitoring in the overflow vessel of a hydraulic power unit�
3: Minimum level monitoring�
2 3
UK
29