Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.3 Steering wheel
Put together the steering wheel using parts
178 and 228.
Remove the brass ring from the etching board
and scrape the reverse with sandpaper. Then
stick it onto the steering wheel with super glue.
Now drill the 0.7 mm holes for the brass nails
and insert them.
Insert the shaft part 179 and attach it to the
wheelhouse.
Updated June 2016
11.4 Grating cockpit
Adapt part 117 to the cockpit. Stain the grating
as desired.
11.5 Toe rail
Remove parts 107 from the laser board and
stick together in pairs so that the markings for
the boreholes are on the inside. After allowing
the glue to dry, drill 1.5 mm holes on the mark-
ings visible at the top. Now the toe rails can be
sanded clean and rounded.
Page 25
©
Krick Modelltechnik Knittlingen
Werbung
