krick ANTARES Baubeschreibung Seite 72

Anchor
Mount the anchor 194.
Stand for flagpole
Put together the stand for the flagpole using
parts 200 and 199.
Sand the edge of the borehole in the flange
using a round file. Then diagonally solder or
stick the base and the stand.
11. Wooden fittings
11.1 Cleats
To create the cleats, remove parts 108 from
the laser board.
Updated June 2016
Stick together the parts such that the markings
for the mounting holes are on the inside. Now
drill the 1.5 mm mounting holes. The laser
markings give the drill a guide.
Now round the edges and paint the cleats.
11.2 Pin rail
Glue together 2 each of parts 109 and 110 to
create the pin rail.
Insert 1.5 mm brass pins into the struts. After
the pin rail has been painted, it can be placed
on the deck.
Page 24 ©
Krick Modelltechnik Knittlingen