Basic Recommendations And Tips For Use; Appliance Pairing - eta MASTER 2 PRO Gebrauchsanleitung

BASIC RECOMMENDATIONS AND TIPS FOR USE

• Dual Wi-Fi network: If you have a smart Wi-Fi router in your
home that automatically switches the network frequency
between 2.4 GHz and 5 GHz (within one SSID of the network
name), there may be problems with pairing or disconnection
from the Internet during operation. If these problems occur,
we recommend switching the router to broadcast two separate
frequencies (SSID names), one at 2.4 GHz, the other at 5 GHz.
This setting is usually set in the administration interface of the
Wi-Fi router. If you cannot change this yourself, contact your
network administrator or IT specialist.
• Due to better features, range and connection quality we
recommend using the 2.4GHz network.
• The robotic vacuum cleaner with laser navigation is able to
navigate excellently in space and thus clean up with high
preciseness. Under normal circumstances, it is able to
recognize its position if you replace it within one map to another
place, although we don't recommend it. Always start the robot,
if possible, from the charging station, and - if possible - don't
manipulate with it.
• As soon as the robot once creates a map, avoid excessive
changes of the environment, which could confuse the robot,
or which could cause erasing the map. It could be, for example,
replacement of furniture, movement of some persons next to
the robot (most frequently, children:)), etc.
• Pay special attention to the doors. If you want to make
available a room for the robot, the door has to be open during
mapping. To the contrary, close the door. It is also possible not
to close the door and prohibit the robot from access by means
of a prohibited zone.
• If you transfer the robot to another part of your house (to
another map), change this map directly in the application
before switching-on the robot. To the contrary (i.e. if you start
the robot from another place within a different map), the robot
could be confused and could draw a map incorrectly.
• If you are planning to use the robot, we recommend that you
fully charge it first.
• Ideally, always let the robot finish the cleaning task. Don't
interrupt it and don't enter more orders or operations than
is necessary.
• If the map is deleted or in case of non-standard behavior, first
restart the robot and then insert it manually into the charging
station.

3. APPLIANCE PAIRING

• Connect your mobile phone (tablet) to your
Wi-Fi network.
1 • Switch-on ETA SMART Application and login
to your account.
• After that, click on
the right upper corner).
2 • Select the
„ETA6229 Master
cleaner.
• Enter your Wi-Fi network name
3 and password.
• Click on „Next".
4
„Add Device" (or to „+" in
Pro" vacuum 5
Wi-Fi 1
Wi-Fi 2
6
Wi-Fi 3
• Press and hold the both buttons on the control
panel of the vacuum cleaner for at least
3 seconds.
• Check and confirm that light signalization
on the vacuum cleaner is slowly blinking.
• Afterwards click on „Next".
• Click „Go to Connect" and then you will be
automatically redirected to phone settings.
Go to the list of Wi-Fi networks available on
your phone (tablet).
• Select the Wi-Fi network of the vacuum
cleaner named „SmartLife- / ETA-smart..."
and wait for the connection with the vacuum
cleaner. You may then see „Internet may not
be available" etc., which is fine. The mobile
phone (tablet) is connected to the vacuum
cleaner and the next step is the pairing
process.
• Now go back to the ETA SMART application.
To return, click on the top left „left arrow < „,
or select back „<" using the navigation system
buttons (valid for Android). For Apple phones,
„< Eta Smart" in the top left corner.
select
ENG
ENG - 36