Herunterladen Diese Seite drucken

Husqvarna DM1 PACE Bedienungsanweisung Seite 22

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Indication on the prod-
uct
1 green LED.
2 green LEDs.
3 green LEDs.
3 green LEDs and 1 yel-
low LED.
3 green LEDs, 1 yellow
LED and 1 red LED.
All LEDs flash.
Transportation and storage
The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
Obey the special requirement on package and labels
for commercial transportation, including by third
parties and forwarding agents.
Speak to a person with special training in dangerous
material before you send the product. Obey all
applicable national regulations.
Use tape on open contacts when you put the battery
in a package. Put the battery in the package tightly
to prevent movement.
Remove the battery for storage or transportation.
Put the battery and the battery charger in a space
that is dry and free from moisture and frost.
Do not keep the battery in an area where static
electricity can occur. Do not keep the battery in a
metal box.
Put the battery in storage where the temperature is
between 5°C/41°F and 25°C/77°F and away from
open sunlight.
Put the battery charger in storage where the
temperature is between 5 °C/41 °F and 45°C/113°F
and away from open sunlight.
Use the battery charger only when the surrounding
temperature is between 5°C/41°F and 40°C/104°F.
Charge the battery 30% to 50% before you put it in
storage for long periods.
22
Cause
The battery is installed and the product is
prepared for operation.
Power output is less than 50% of available
output power.
Power output is between 50% and 65% of
available output power.
Power output is between 65% and 80% of
available output power.
Maximum power output. Power output is
more than 80% of available output power.
There is a system overload.
The motor overload protection is started.
The motor overload protection has stopped
the motor.
Transportation, storage and disposal
Possible solution
N/A
Decrease the load to prevent start of the
motor overload protection.
Decrease the load to go back to correct
operation.
To reset the motor overload pro-
Refer to
tection on page 17 .
Put the battery charger in storage in a space that is
closed and dry.
Keep the battery away from the battery charger
during storage. Do not let children and other not
approved persons to touch the equipment. Keep the
equipment in a space that you can lock.
Clean the product and do a full servicing before you
put the product in storage for a long time.
Attach the product safely during transportation.
Disposal of the battery, battery charger
and product
The symbol below means that the product is not
domestic waste. Recycle it at a recycling station
for electrical and electronic equipment. This helps to
prevent damage to the environment and to persons.
Speak to local authorities, domestic waste service or
your dealer for more information.
Note:
The symbol shows on the product or package of
the product.
1941 - 005 - 25.09.2023

Werbung

loading