Husqvarna DM1 PACE Bedienungsanweisung Seite 16

CAUTION:
hit the drill bit.
CAUTION:
necessary. This only makes the operation
slow and causes overload to the motor.
1. Start the product. Refer to
page 14 .
2. Let the motor speed increase to the maximum speed
before the drill bit touches the surface.
3. Push the drill bit into the surface with the feed lever
on the drill stand.
4. If you drill through iron reinforcements, obey the
To drill through iron on page 16 .
instructions in
5. Use very small pressure initially to keep the drill bit in
correct position.
6. During operation, make sure that the water removes
all waste material from the drill hole. Adjust the water
pressure if it is necessary.
7. Stop the product. Refer to
page 17 .
To drill a starter hole
™
The Slow Start function decreases the speed of the
motor. This helps to make a starter hole.
Note:
Only use the Slow Start
hole. The power will be very much decreased if it is used
during usual operation.
1. Start the motor. Make sure that the drill does not
touch the material.
16
Make sure that no objects
Do not use more force than
To start the product on
To stop the product on
™
function to start a
™
2. Push the Slow Start
speed is decreased and the LED indicator on the
™
Slow Start button is on while the Slow Start
function is on.
3. Drill a starter hole in the material.
™
4. Push the Slow Start
increased back to usual speed.
The speed is automatically increased back to usual
speed 1 minute after start of the Slow Start
function if the Slow Start
again.
To drill through iron
The re-bar button decreases the speed of the motor
to make it easier to drill through iron, for example
reinforcement bars.
Note:
Only use the re-bar button to drill through iron.
The power will be very much decreased if it is used
during usual operation.
1. Start the motor. Make sure that the drill does not
touch the material.
button (A) one time. The
™
button (A) again. The speed is
™
™
button (A) is not pushed
1941 - 005 - 25.09.2023
A