Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
This device may not cause harmful interference
•
This device must accept any interference received,
including interference that cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, disconnect the battery
from the product.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
1. Read the operator's manual for the drill motor
carefully and make sure that you understand the
instructions.
2. Read the operator's manual for the drill stand
carefully and make sure that you understand the
instructions.
3. Do the daily maintenance. Refer to
schedule on page 18 .
4. Use personal protective equipment. Refer to
Personal protective equipment on page 8 .
5. Make sure that the work area is clean and bright.
1941 - 005 - 25.09.2023
Assembly
Before you assemble the
To prevent accidental start
Operation
Read and understand the
Maintenance
licence. L'exploitation est autorisée aux deux conditions
suivantes:
•
l'appareil ne doit pas produire de brouillage, et
•
l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
To attach the product to a drill stand
CAUTION:
for the drill stand carefully.
•
To attach the product to a drill stand, refer to the
manual for the drill stand.
•
Use only with approved Husqvarna drill stands.
6. Make sure that the product is installed correctly. The
drill bit and the drill stand must be attached correctly.
7. When you do inverted drilling, make sure that you
comply to the applicable instructions. Refer to
prepare the product for inverted drilling on page 12 .
8. Make sure that the water system is not damaged
and that it is connected to the product.
Read the operator's manual
To
11
Werbung
