eta AQUILO PRO Bedienungsanleitung Seite 54

EN
Standby mode (Pause)
After switching on, the robot vacuum always goes to standby mode. If the vacuum robot is
in operation mode (i. e. cleaning is being carried out), it can be switched to standby mode
by pressing C1/C2.
The robot vacuum must start cleaning from its base. Therefore, put the base on a
suitable place, according to the instructions above, and do not change this location.
Sleep mode / automatic switching off
If the robot vacuum will stop in the room, it will be automatically switched to sleep mode
after 5 minutes of inactivity. After following approx. 6 hours (in sleep mode), it will be
switched off automatically. Then the robot vacuum must be switched on again by long
pressing button C1 (approx. 3 seconds).
If the robot vacuum is in the base connected to electric mains, it will never be
switched to sleep mode and automatically switched off.
5.4 CLEANING MODES AND DEVICE FUNCTIONS WITHOUT USING THE ETA AQUILO
APPLICATION
Smart automatic cleaning
Press button C1. During cleaning, the vacuum cleaner moves gradually and systematically
in the space according to the programmed route. It divides the space into individual
segments. As soon as the cleaning programme has been completed, the robot vacuum
returns to the base automatically.
Return to the base
After completion of the cleaning programme, the robot vacuum automatically returns back
to the base. Or it can be sent to the base by pressing C2.
Factory settings
Press C2 for approx. 5 seconds. Voice message will be heard. Then press C2 again for
approx. 5 seconds to restore factory settings.
When factory settings has been restored, all settings you have performed
5.5 MOPPING
Check correct installation of all items necessary for mopping (cleaning grate D2, tank E,
tank F, rotation clips H for mops and mops H1). Press C1 to start automatic cleaning (see
above). In the course of mopping, the robot vacuum will automatically return to the base
for the purpose of cleaning and wetting the mops. After completion of mopping, the robot
vacuum will return to the base for final cleaning and drying the mops.
This allows the device to return back to its base.
using "ETA AQUILO" app will be reset.
EN - 54
Note
Note
NOTE