Parkside PBTS 370 B2 Originalbetriebsanleitung Seite 26

Such damaged electrical connection cables must not be used
and are life-threatening due to the insulation damage.
Check the electrical connection cables for damage regularly.
Ensure that the device is disconnected from electrical power
when checking for damage.
Electrical connection cables must comply with the applicable
VDE and DIN provisions. Only use connection cables of the
same designation.
The printing of the type designation on the connection cable
is mandatory.
Safety information for replacing damaged or de-
fective mains connection cables
Type Y
If it is necessary to replace the connection cable, this must
be done by the manufacturer or their representative to avoid
safety hazards.
14.2 AC motor
• The mains voltage must be 230-240 V~.
• Extension cables up to 25 m long must have a cross-section
of 1.5 square millimetres.
Connections and repair work on the electrical equipment may
only be carried out by electricians.
Please provide the following information in the event of any
enquiries:
• Type of current for the motor
• Data of machine type plate
15. Disposal and recycling
The device is supplied in packaging to avoid transport dam-
ages. This packaging is raw material and can thus be used
again or can be reintegrated into the raw material cycle.
The device and its accessories are made of different materi-
als, such as metals and plastics. Take defective components to
special waste disposal sites. Check with your specialist dealer
or municipal administration!
The packaging is wholly composed of environmen-
tally-friendly materials that can be disposed of at
a local recycling centre.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
electrical devices.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must not be dis-
posed of together with domestic waste in compliance
with the Directive (2012/19/EU) pertaining to waste
electrical and electronic equipment (WEEE). This prod-
uct must be handed over at the intended collection point. This
can be done, for example, by returning it when purchasing a
similar product or delivering it to an authorised collection point
for the recycling of old electrical and electronic devices. Im-
proper handling of waste equipment may have negative conse-
quences for the environment and human health due to poten-
tially hazardous substances that are often contained in
electrical and electronic equipment. By properly disposing of
this product, you are also contributing to the effective use of
natural resources. You can obtain information on collection
points for waste equipment from your municipal administration,
public waste disposal authority, an authorised body for the dis-
posal of waste electrical and electronic equipment or your
waste disposal company.
GB 21