Coccolle Lissia Bedienungsanleitung Seite 17

EN
Assembly/Usage
Check if following spare parts are in the box:
A. Carry cot body with canopy including mattress
B. Top cover
C. Sun shield
D. Inner liner
1. If one or more of the above-mentioned spare parts are missing or broken,
please contact the store where you bought the product, before using.
2. Open the package and take out the parts. Pull frame wires out until it clips
into the holder on both sides.
3. Press the buttons as shown in the picture to adjust the canopy in direction up
or low.
4. Put the liner into the carry cot and then zip it. Pull up the zipper of the sun
shield and canopy.
5. Fasten the elastic cord and button of top cover on to the handle.
FITTING CARRY COT ON TO THE CHASSIS (FORWARD AND REVERSE)
Clamp the carry cot to the frame in the direction of the arrow and verify that
carry cot is fully locked in place.
REMOVE CARRY COT FROM THE CHASSIS
Press the lock buttons on both sides and pull up the carry cot.
Adapters
Assembly/ usage
WARNING: Before you insert the adapter key to the connector, please make
sure you will follow the instruction.
Step 1: Insert the car seat adapter key to the car seat connector.
Note: put R part on right side and L part on left side.
Step 2: Insert the car seat into the stroller adapter key.
WARNING: Please always make car seat face to handle bar when attaching it to
chassis.
Disassembly
Step 1: Press the buttons on car seat to release the car seat.
Step 2: Press the adaptor button and lift the adaptor out of the frame.
CAR SEAT
Usage in the vehicle
If the infant car seat is placed on the vehicle seat in a way that is not stable or at
too steep an angle, it can be adjusted with an additional blanket.
WARNING! Do not use the infant car seat on a seat on which a front airbag is
activated. The large-volume front airbag expands explosively and may cause
your child serious injury or even death.
The infant car seat only offers the best possible protection when exactly
following the instructions given in this manual. No modifications or additions may
be made to the infant car seat without the approval of manufacturer. Repairs
may only be undertaken by persons who have been authorized to do so. In
doing so, they must always use original components and accessory parts only.