Coccolle Lissia Bedienungsanleitung Seite 14

EN
Assembly
Check if following spare parts are in the box:
• Chassis
• Rear wheels
• Seat including upholstery and canopy
• Front bumper
• Rain cover
• Adapter set for MC car seat
If one or more of the above-mentioned spare parts are missing or broken,
please contact the store where you bought the product, before using.
WARNING! Please keep all packaging material away from babies and children,
to prevent suffocation.
1. Unfold the stroller
Open the package and take out the parts. Lift up the handle bar and fling open
the stroller as pict. 1 and 2. When you hear a CLICK the frame is unfolded
completely and verify frame is fully locked in place.
2. Assembly/ disassembly front wheel
Pict. 4: Plug the wheel bearing into the wheel housing until you hear a click, it
indi-cates that the wheel is installed in place. Please try to move and rotate all
the wheels by your hand to make sure all the wheels are firmly fixed on wheel
houses before use.
Pict. 5: The front wheel can swivel all the way.
Push the small lock up (off) and down (on) to swivel or not.
Pict. 6: The wheels can be removed quickly by pressing the arrow button shown
on picture 6 and pulling out the wheel at the same time.
3. Assembly/ disassembly rear wheel
Pict. 7: Plug the wheel bearing into the wheel housing until you hear a click, it
indi-cates that the wheel is installed in place. Please try to move and rotate all
the wheels by your hand to make sure all the wheels are firmly fixed on wheel
houses before use.
Pict. 8: The wheels can be removed quickly by pressing the arrow button shown
on picture 8 and pulling out the wheel at the same time.
4. Open the seat
Pict. 9: Open the seat along the direction of the arrow until you hear "CLICK"
and verify that the seat is fully locked in place as picture 10.
Pict. 10: Open the front armrest along the direction of the arrow until you hear a
click and verify that the armrest is fully locked in place as picture 11.
5. Install/ remove seat (forward & reverse)
Pict. 12: Forward installing seat: clamp the seat to the frame in the direction
indicated by the arrow and verify that seat is fully complete locked in place, see
pict. 13. Pict. 14: Reverse install seat: clamp the seat to the frame in the
direction indicated by the arrow and verify that seat is fully locked in place. Pict.
15: Press the seat lock button and pull the seat up with hand, remove the seat
completely.
6. Install/remove/open the bumper bar
Picture 16: Insert into the both side plastic hole of the front armrest holder until
you hear "CLICK" and verify that armrest is fully completely locked in place.