Timex W217 Benutzerhandbuch Seite 2

Congratulations on purchasing your TIMEX
instructions carefully to understand how to operate your Timex timepiece...
Your watch may not have all of the features described in this booklet... For
more information, please visit: www...timex...com
HOW TO START YOUR WATCH
Quartz Movement: To start your watch remove the plastic guard from under
the crown, then press the crown in against the case... The second hand will
begin advancing in one-second intervals...
Some deep-depth water-resistant watches require the setting crown to be
screwed in to secure water-resistance... If your watch case has a protrusion
with screw threads, the crown must be screwed in after setting the watch...
To screw in, push the crown firmly against the threaded protrusion and hold
in while turning the crown clockwise... Continue to screw in the crown until it is
tight... You will need to unscrew the crown (counter-clockwise) before pulling
it out the next time you want to set your watch...
Solar Movement: The watch includes a solar cell that charges its battery...
Expose the watch in direct sunlight, sunlight through a window, or artificial
(indoor) lighting to charge the battery prior to use... When fully charged, the
watch may function without additional charging for up to 2 months...
To start your watch, remove the plastic guard from under the crown, then
press the crown in against the case... The second hand will begin advancing
in one-second intervals...
Charging happens faster while in direct sunlight and slower when indoors... A
depleted battery may be charged by exposing the dial to sunlight for several
days... Wear watch so that the sleeve does not cover all or part of the dial
and impede charging... Store watch where it will be exposed to light or the
battery will run down and require a full charge... See the table below for more
information...
WARNING: Leaving the watch in direct sunlight or close to a lamp may
cause the watch to become hot... Handle with care...
After many years of use, if the battery becomes unable to charge fully, it may
be replaced with a new rechargeable battery of the same type... Please see
BATTERY section for details...
Illumination Light
(Lx) Source
Fluorescent
700
Light
Incandescent
3,000
Light
10,000 Sunlight
100,000 Sunlight
Hand-wind Movement: To start your watch remove the plastic guard from
under the crown, set the Time and Date (if applies) then press the crown in
against the case... Slowly turn the crown clock-wise until you feel resistance...
You should hear the watch "ticking" and the second hand will begin to move...
If the watch stops in the next 24 hours, you should increase the amount of
clock-wise turns of the crown during the winding process until you find the
watch will work for 24 hours without stopping... You should wind the watch
each 24-hour period at approximately the same time of day to ensure the
watch does not become fully un-wound and stops... If the watch stops, follow
the instructions to set the Time and Date (if applies), and wind to start the
watch again...
watch... Please read these
®
Full
Charge
Environment
from
Empty
Office Lighting N/A 100 Minutes
150W Lamp
(8" / 20cm 60 Hours
distance)
Cloudy
20 Hours
Weather
Clear Weather 5 Hours
WATER AND SHOCK RESISTANCE
If your watch is water-resistant, meter marking or (O) is indicated...
Water-Resistance Depth
30m /98ft
50m /164ft
100m /328ft
200m /656ft
*pounds per square inch absolute
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY
BUTTONS OR PULL OUT THE CROWN UNDER WATER UNLESS YOUR
WATCH IS INDICATED AS 200 METER WATER-RESISTANT.
1... Watch is water-resistant only as long as lens, push buttons and case
remain intact...
2... Watch is not a diver watch and should not be used for diving...
3... Rinse watch with fresh water after exposure to salt water...
4... Shock-resistance will be indicated on watch face or caseback... Watches
are designed to pass ISO test for shock-resistance... However, care should
be taken to avoid damaging crystal/lens...
INDIGLO
Press button or crown to activate light... Electroluminescent technology used
in the INDIGLO
light conditions...
Charge for
One Day's
DATE MODELS
Operation
TO SET TIME:
1... PULL crown all the way out and turn to correct time...
2... Push crown in to restart... For screw-in setting crown, push crown in while
turning CLOCKWISE to tighten...
Watches with date: Note correct time of day (A...M or P...M...) for proper date
function...
25 Minutes
TO SET DAY:
1... PULL crown to "middle" position and turn CLOCKWISE until correct day
appears... If day does not change, pull crown to "out" position and turn
8 Minutes
CLOCKWISE or COUNTERCLOCKWISE through necessary number of
24 hour periods until correct day appears...
2 Minutes
TO SET "QUICKDATE
3-POSITION CROWN:
1... Pull crown to "Middle" position and turn CLOCKWISE or
COUNTERCLOCKWISE until correct date appears...
2-POSITION CROWN:
1... Pull crown to "OUT" position and turn CLOCKWISE until date changes...
Repeat until correct date appears... Adjust date when month has less than
31 days. Push crown in when finished.
Caution: Wearing or storing the watch with the crown in the "middle"
position will cause damage to the movement... Always return the crown to the
normal position, or if you wish to save the battery life while storing the watch,
leave the crown in the "out" position...
1
p.s.i.a. * Water Pressure Below Surface
NIGHT-LIGHT
®
night-light illuminates entire watch face at night and in low
®
DATE
A B C
" FEATURE:
®
ENGLISH 990-095926-05
60
86
160
284
CROWN POSITION