Endress+Hauser Promag 10 Einbauanleitung Seite 10

EA00082D
Special screw! Do not loosen the screw completely or replace it with another one. Only
use original parts from Endress+Hauser.
1 →
‣
Turn neck component and release
screws.
7.1.1 Reassembling the transmitter housing
Reassembly is carried out in reverse order. Note the following:
When installing, use new housing seals!
1 →
For detailed information on the electrical connection, see the "Electrical connection"
section of the Operating Instructions for the device.
For detailed information on commissioning, see the "Commissioning" section of the
Operating Instructions for the device.
10
2
12 Nm
8 mm
‣
Turn the transmitter and lift it
off.
2
‣
Acid-free, non-hardening
lubricant
2.
1.
Endress+Hauser