Parkside PSG 85 B2 Originalbetriebsanleitung Seite 27

Assembly
Always fi x the device with the sup-
plied screws (M10x70).
Ensure that you have suffi cient
space in which to work, and that
you do not endanger other people.
Always fasten the device on to the
worktop with screws of suffi cient
length and thickness in order to
maintain control of the device.
Assembling the grinder
1. Remove the cable ties.
2. Screw the handgrip (4) onto the grind-
ing head (2).
3. Loosen the retaining screw (9) on the
chain tensioning unit (11).
4. Place the chain tensioning unit (11)
on the grinding base (8) and tighten it
with the retaining screw (9).
5. Secure the mains connection cable (16)
in the cable holder (15).
Fixing adjusting screw:
6. Screw the adjusting screw with the
adjusting nut for the depth stop (
through the threaded hole on the back
of the device.
Setting up the device
- Thickness of table edge: 20-30 mm
- Drill diameter: 10.5 mm
- Screw gauge: M10
1. Use the stop notch (22) to position the
device on the worktop (21). The grind-
ing base (8) must project over the edge
of the table.
2. Mark the drill holes with a pen and
remove the device.
3. Drill two holes into the worktop (21).
4. Screw the grinding base to the worktop
using the screws (23), washers (24a)
and nuts (24) supplied.
Working with the device
Caution!
Only use grinding discs and acces-
sories recommended by the manu-
facturer. Using other attachment
tools and other accessories may
represent a risk of injury to you.
Never operate the device without a
viewing guard.
Do not use any saw blades.
Always remove the mains plug be-
fore working on the device.
Always inspect the grinding disc
before starting the device: Check
the distance between the viewing
guard and the grinding disc. Do
not use any broken, cracked or oth-
erwise damaged grinding discs.
Only switch the device on once it is
safely fi xed to the worktop.
Never operate the device without
a viewing guard, chain tensioning
6) unit or grinding disc cover.
Risk of injury!
Make sure that you have a
secure footing when working
and always ensure that the
device is securely fastened to
the worktop.
Caution! Risk of injury!
Wear eye and hearing protection!
When working with the saw chain,
wear cut-resistant protective gloves
and, if necessary, an apron to pre-
vent cuts.
GB MT
27