Installation Procedure (Sequential); Actuators - Danfoss CF-MC Anleitung

Instruction CF-MC Master Controller

5. Installation Procedure (Sequential)

Important Note: Complete all the installations on the Master Controller
described below before connecting to a 230V power supply !
5.1 24V Actuators
• Connect the two actuator wires to an output (fig. 8)
• Fix the cable
Round cable (fig. 9)
Squared/flat cable (fig. 10)
Note: If NC (normally closed) actuators are installed for ON/OFF regula-
tion, no further actuator output configuration is needed (see 6.1) !
VI.UH.K1.52
Produced by Danfoss Floor Heating Hydronics 08.005
7