Parkside PAP 20 B1 Originalbetriebsanleitung Seite 10

Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket. The green
charge control LED
red charge control LED
♦ The green control LED
charging process is complete and the battery
pack is ready.
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
broken.
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes be-
tween successive charging sessions. Also discon-
nect the power plug from the mains power socket.
PAP 20 B1 + PLG 20 C1
to the high-speed
(see fig. A).
lights up briefly, then the
lights up.
indicates that the
flashes, this means
has overheated and
both
into the appliance.
Checking the battery charge level
♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Maintenance and storage
■ If you do not intend to use the appliance for
an extended period, remove the batteries and
store it in a clean, dry place away from direct
sunlight.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
■ Never try to repair damaged batteries.
Maintenance of batteries should only be car-
ried out by the manufacturer or an approved
customer service centre.
is
to
as follows:
GB │ IE │
5 ■