Herunterladen Diese Seite drucken

Technics SL-1000R Bedienungsanleitung Seite 12

Plattenspieler mit direktantrieb

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 33
Adjustment
(continued)
Tone arm height
Make this adjustment only if the cartridge you
are using makes it necessary.
Preparation
z Put a record on the turntable.
1
Release the arm lock.
(Released)
Arm lock
(Locked)
2
Adjust the height with the
arm-height control ring.
Adjust the arm-height until the tone arm
becomes parallel to the record.
Turn the arm-height control ring to align the
position mark with the index line.
0 to 15 mm are marked on the arm height
control ring.
Index line
Arm-height control ring
Attention
z Selecting a smaller scale mark lowers the
arm-height control ring.
Prevent an object from being caught by the
arm-height control ring.
22
(22)
English
3
After arm height adjustment is
finished, lock the tone arm by
turning the arm lock knob.
z Be sure to turn the arm lock knob to the
end as shown in the figure below. You
may need to apply some force to do so.
Remove the stylus cover, taking care not to
damage the stylus, then release the arm clamp.
Lower the cue lever, rest the stylus on the
record and adjust the height control until the
tone arm and record are parallel.
Parallel to a record
Attention
z Be careful not to damage the stylus tip.
z Do not use the product with the arm lock
released.
z For finer adjustment, use a level (not included)
to adjust the arm-height so that the cartridge
becomes parallel to a record.
Armlift height
Make an adjustment according to your
cartridge if necessary.
Preparation
z Put a record on the turntable.
z Remove the stylus cover, taking care not
to damage the stylus, then release the arm
clamp.
z Lift the cue lever and move the tone arm over
the record.
1
Check the armlift height (distance
between the stylus tip and record
surface).
If adjustment is needed, go to
step 2 .
2
Return the tone arm to the arm
rest, clamp it with the arm clamp
and while pressing the armlift
down with your finger, turn the
screw to adjust the height.
z Turning the screw clockwise lowers the
armlift.
z Turning the screw anti-clockwise raises
the armlift.
Armlift screw
Armlift
Arm clamp
23
(23)
English

Werbung

loading

Diese Anleitung auch für:

Sl-1000re-s