Werbung
Verfügbare Sprachen
Verfügbare Sprachen
with collective equipment such as arrestor nets or
personal protective equipment such as arrestor
systems to EN 363.
1) Selection of the correct harness size
Size
Waist
Standard
88 – 124 cm
2a) Correct use of the push-through harness
closures and adjustment buckles:
fig. 2
1. Feed the loose harness end with the push-through
buckle through the O-shaped buckle from below
(fig. 2)
2. Place the push-through buckle parallel to the
O-shaped buckle (figs. 3 and 4)
fig. 5
3. Tighten the harness by pulling on the ends of the
harness belts (fig. 5)
4. Open the harness by pulling on the flap (fig. 6)
Thigh
66 – 98 cm
fig. 3
fig. 4
fig. 6
2b) Correct use of the safe-click buckle
fig. 7
Closing the buckle (fig. 7)
1. Push the buckle parts together until you hear the
"click"
2. check correct function/locking of the buckle (parts
of the buckle must be able to move freely with a
gap of 2-3 mm between the parts when locked, pull
at both parts)
Opening the buckle (fig. 8)
1. Push the buckle parts together and at the same time
2. Push the unlocking buttons in the opposite direction
3. Pull the buckle parts apart
3) How to put the harness on correctly
1. Climb into the pelvic belt and the leg loops with both
legs (fig. 9).
2. Pull the pelvic belt up to the hip (fig. 10).
3. Close the pelvic belt and pull tight (fig. 11,).
4. Adjust the leg loops to the correct size (fig. 12)
fig. 9
fig. 11
fig. 13
Use
2
1
1
3
2
fig. 8
fig. 10
fig. 12
5
Werbung
